A Steam Solution for Cultivation of Strawberries in Raised Rows is Ready for Use

Producto de MSD AG Möschle-Seifert-Dämpftechnik

FRUIT LOGISTICA 2019

Contáctenos

Información personal

Por favor introduzca su nombre.
Por favor inroduzca su apellido.
Por favor, introduzca su nombre de empresa.
*datos obligatorios

Su mensaje

Por favor introduzca un mensaje.
Por favor seleccione un destinatario.

Enviar mensaje

Su mensaje se ha enviado correctamente.
Enviar otro mensaje.

Stollenberg 8
77770 Durbach
Baden-Württemberg
Alemania

Teléfono / Fax: mostrar
Teléfono: +49 781 127 866-60
Fax: +49 781 127 866-69
FRUIT LOGISTICA 2019

Compartir link

Recomendar

Recomendación de A Steam Solution for Cultivation of Strawberries in Raised Rows is Ready for Use

Separe los e-mail con una coma. Los destinatarios recibirán un link a esta plataforma.

Por favor introduzca un destinatario válido.
Por favor introduzca una dirección válida de e-mail.
Por favor introduzca un mensaje.
*datos obligatorios
Su recomendación se ha enviado con éxito.
Enviar otro mensaje.

Descripción del producto

In strawberry cultivation, soil nematodes, soil-borne fungus, and weeds must be combated. This often presents a problem, not least of all because of a lack of — or a lack of approved — pesticides. Soil steaming offers an appropriate solution for this issue.
The company MSD — Möschle, Seifert Dämpftechnik — from Durbach, Germany, has developed a revolutionary technology for the cultivation of strawberries in raised rows. In this process, steaming is conducted as the last step before planting.
For raised rows with typical dimensions and a double row of strawberries, 3-meter-long steam hoods are used for each raised row with a plant spacing grid of 30 x 30 cm. The steam hoods are fitted with spikes approximately 30 cm in length which route the steam directly into the raised row.

An MS 200 steam generator from the company MSD, Durbach is used to produce the steam. It has a maximum steam output of 250 kg/h with an operating pressure of 0.5 bar and a steam emission temperature of 200 °C.

The results of this test showed that the spikes and the hot steam did not damage the plastic foil on the rows. No heat adhesions could be detected; the same is true of the areas where the steam hood came in contact with the plastic foil. Sufficient heat flow in the raised row was found. As expected, the highest temperatures of over 90 °C were found in the areas immediately surrounding the steam spikes’ points of penetration. On the outer surface of the raised row, temperatures of at least 75 °C could still be found. These temperatures are definitely sufficient to eliminate soil nematodes, soil-borne fungus, and weeds. It is assumed that soil fatigue can likely also be eliminated.

Initial mycological test results from the laboratory at the Agricultural Technology Center in Augustenberg show that steaming through only the planting holes is sufficient to completely kill off all pests. After steaming the affected soil, no living verticillium fungus could be verifiably documented. The temperatures which were reached — between 70 – 80 °C — killed it off entirely.
This proved that sufficient steam distribution — and, consequently, temperature distribution — for the desired hygienization can be achieved with a 30 cm steam spike grid on a ready-to-plant bed that is covered with mulch film.
The experiments were conducted in cooperation with the agricultural office of Bruchsal.
Steaming hood weighed down on film-covered experimental raised row

Grupos de productos